ARIES™ HOME (NAVS500)INSTRUCTION MANUALWIRELESS HD TRANSMITTER
10FAQank you for your purchase of the Nyrius Aries Home/Home +. If you require any assistance please review the below Frequently Asked Questions. 1
11TX/RX WILL NOW BE PAIRED : 1. RX (Receiver) : Remove mini USB power adapter, make sure RX is without power. 2. Press Power button and then plug-
12AUDIO BIT RATE:Digital Audio from HDMI inputs: Up to 6Mbit/s bit-rate support. Support AC3 and DTS. 2-channel PCM: 16~24 bits audio sample with 32
13SUPPORTED RESOLUTIONS:2D VIDEO FORMAT RESOLUTION SUPPORT640x480p @ 59.94 / 60Hz 480p YES720x480p @ 59.94Hz 480p YES720x480p @ 60Hz 576p YES720x57
14FCC STATEMENTThis device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: 1. This device may not caus
15SAFETY INFORMATIONRead all instructions.Keep these instructions.Heed all warnings.Follow all instructions.Do not use this apparatus near water.Cle
16WARRANTYThank you for choosing NYRIUS® Consumer Electronics Products!NYRIUS gives the following express warranty to the original consumer purchase
What's Included ...3Overview ..
OVERVIEW 3WHAT'S INCLUDEDTransmitterReceiverQuick Installation Guide Mini Power USB AdapterIR Blaster cableHDMI cableAnchors x2USB Power SupplyIR
4INSTALLATIONTransmitterConnect 1 high-denition audio/vid-eo source to the transmitter Connect the supplied power adapter to the DC IN jack of the
5IR ExtenderPlug the external IR remote extender lead into the IR socket on the back of the transmitter place the IR remote extender bubble in front
6POWERDuring the warm-up, the POWER LED will blink un-til connection between the TRANSMITTER and the RE-CEIVER is established. It will take 15 - 20
7OSD (ON SCREEN DISPLAY) DESCRIPTIONMode Status Description OSD Display (on RX)Rx: Standby Tx: Active-Standby Solid REDPower saving mode.
8WALL MOUNTING:(1) Drill pilot holes.(2) Insert the supplied two Anchors into the wall.(3) Insert two screws into the anchors. Leave 1/8” length for
9TROUBLESHOOTING: No Video - Check the status of the Link LEDs, and check if the HD device is working nor-mally. - Check the HDMI lead is undamaged
Comments to this Manuals